Shimano Hyperglide Cassette Lockring

Other products in the category Small Parts:

Shimano 9 Speed Dura-Ace STI Lever Name Plate -- Shimano Dura-Ace STI Lever Name Plate, Screw sold separately. Make your Dura-ace 9 speed STI levers look new again after that fall or crash.

Shimano 9 Speed Ultegra ST-6510 STI Lever Name Plate -- Shimano Ultegra STI Lever Name Plate and Screw. Make your Ultegra 9 speed STI levers look new again after that fall or crash.

Shimano Canti Cable Yolks -- Shimano canti-lever cable yolks are some of the most common on the market, plus they are super light weight! Use them on MTB or Cyclocross bikes. Sold individually, if you need enough for a complete bike please order 2.

Shimano Chain Pin -- Maintain the integrity of your Shimano chain always use one of these special pins for re-assembly any time you break the chain.

Shimano Down Tube Cable Stops -- Shimano cable stops make cable adjustment easy.

Shimano Dura-Ace Derailleur Cable Set -- Includes 3 sections of gray 4mm housing 600mm x2, 320mm x 1. Two stainless 1.2mm x 2000mm inner cables. Cable ends and ferrules included.

Shimano Dura-Ace Optical Gear Display -- Shimano Dura-Ace Optical gear displays are compatible with all shifters. They splice into you derailleur cable housing so that you can see roughly what gear you are in.

Shimano XTR V Brake Pads -- 1 Pair of Shimano replacement brake pads. These are designed to replace the rubber on your Shimano XT M739 / XTR M950 brakes. Sold Per Pair, buy 2 of this item if you need enough for a complete bike.

Shimano 4mm Sealed Ferrules -- Compatible with 4mm Derailleur housing. These ferrules are speciallly designed to seal out dirt and grime. Just what you need for CRISP shifts! Available with a nipple for added protection.

Ritchey Shimano Compatible Freehub Body -- Replace your blown free hub body without rebuilding your rear wheel. Comes with 12mm integrated bolt, compatible with Ritchey hubs and Shimano cassettes. To remove the freehub, you are going to have to remove the cassette,then loosen the set screw spacer nut on the drive side, pop out the axel with a light tap of the mallet, (to the non drive side) then witha 12mm allen, go in from the non drive side and loosen the free hub.